Failure to follo
instructions c
The Entertainer™
Activity Center
OWNER’S MANUAL
Model No. __________
Serial No. __________
Dear Customer,
Please fill in the
model and serial
numbers above
from the label
under the tray
of your new
Never leave child unattended. Always
keep child in view while in this product.
Never lift or carry
child in it.
Entertainer™
activity center.
Model 4118
Congratulations on your purchase of a
Graco® Entertainer™ activity center!
Graco is the recognized leader in the
design and manufacture of quality baby
products. We believe your new Graco®
Entertainer™ activity center is a wise
choice, promising many hours of
enjoyment for your baby.
Strings can cause strangulation! DO
NOT place items with a string around
your child’s neck, such as hood
strings or pacifier cords. DO NOT
suspend strings over the activity
center or attach strings to toys.
Product may gradu
the floor as child p
movement of produ
child stays away fr
area such as stairs
pools, sources of h
else that may injur
Before using your activity center, please
take a few minutes to read this Owner’s
Manual. The short time you spend reading
these instructions will help you to use your
activity center properly.
THIS PRODUCT REQUIRES ADULT ASSE
READ ALL INSTRUCTIONS BEFORE ASS
If you experience any difficulties, please con
Customer Satisfaction
Our goal is to make every product the best it
can be! We are also committed to supporting our
products after purchase. If you would like to speak
with Graco about your product, please contact our
Customer Service Department at 1-800-345-4109.
Our knowledgeable staff will be ready to answer
any questions you may have concerning parts, use
or maintenance. When you call, please have the
model and serial numbers ready so your call
may be processed quickly and efficiently.
KEEP INSTRUCTIONS FOR FUTURE USE
THIS PRODUCT IS FOR USE ONLY by a c
unable to walk, weighs less than 30 pounds
EXCESSIVE EXPOSURE TO SUN OR HEA
DO NOT USE THIS PRODUCT if it is dama
THIS PRODUCT IS NOT INTENDED FOR C
2
© 1997 Graco 291-12-97
Step 6.
To Assemble Your
™
Entertainer Activity Center
Turn tray over. Push one leg into socket in tray exactly as
shown until it snaps into place. Repeat for other two legs.
Step 1.
Turn the tray over and
locate the hole that the
seat lock screws into. Place
the seat lock on the tray as
shown and screw it to the
tray. DO NOT overtighten
screw—seat lock must be
free to slide.
Button
faces seat
Step 2.
RIGHT
WRONG
Four tabs are located
behind the indentations
inside the seat ring.
Remove the seat ring by
pulling the four tabs out
from under the tray, one
at a time, while lifting the
seat ring.
Step 7.
On top of tray, CHECK that
snaps are visible through
slots. Pull on leg to be sure it
is securely attached.
Solid color inside
Step 3.
Snaps visible
Put the seat ring upside
down inside the cloth seat.
The high side of the seat
ring goes to the back of the
seat, where the warning
label is located.
Step 8.
Slide the leg tubes on the tray onto the leg tubes on the
base as shown.
Grommet
Pattern side
HINT: If a tray leg tube will not slide onto the base leg tube,
twist the base tube slightly to line up the parts.
Attach the seat to the seat
ring by tucking the seat
edge into the channel and
snapping the grommets on
the pegs.
Push in the buttons on each of the upper leg tubes and
adjust the activity center to the desired height.
The bottom edge of the upper tubes must be even with one
of the three lines on the lower leg tube.
Pattern side UP
CHECK that all three leg tubes are set to the same
height.
Step 4.
Turn the seat over and
push the seat down into the
seat ring.
Step 5.
Buttons
Line
Snap the seat ring back
onto the tray. Make sure all
four tabs are snapped onto
the inside lip.
291-12-97
5
6
Step 9.
Assemble the toys on the tray as shown. The mirror,
squeaker, and music button are already assembled.
Mirror and music button—
NOTE: Most toys may
be removed from tray
for cleaning or storage.
DO NOT allow liquids
around music button.
Insert teether
stalk into the tray.
Mount ring toys onto loop,
then insert ends of loop into
holes on tray. Short end of
loop goes directly over leg.
The loop and ring toys will
not be removable.
Squeaker
(Note:
Squeaker
will not work
in storage
position.)
Place tumbler
Set duck pond in round
into oval space
as shown, then
use two screws
provided to
attach it from
underneath tray.
DO NOT over-
tighten screw.
Tighten screw until
clicker does not
move freely—DO
NOT overtighten—
then loosen screw
slightly.
space provided. Then place
retainer ring over it, pushing
all four tabs into slots in tray.
To Use the Seat Lock
To Adjust the Seat Height
Push gently on latch and
turn the seat until latch
engages in one of the four
stop positions.
Do not adjust height while child is in
activity center.
Step 1.
To allow seat to swivel
again, pull lock out.
Press in the buttons on
each leg to adjust seat
to desired height. The
bottom edge of the upper
tubes must be even with
one of the three lines on
the lower leg tube.
For your child’s safety, all three legs
must be set to the same height. Tray must be level.
7
8
Step 2.
Replacement Parts
After adjusting height of the seat, CHECK that your
child’s feet can rest completely on the floor of your
Instructions for ordering activity center parts:
Complete form below. Your model number MUST be
included on the form to ensure proper replacement parts.
Your model number can be found on a sticker on the bottom
of the tray. Payment must accompany your order.
activity center
. Tray should not be too high or too low.
Remove child and readjust height if necessary.
Parts List:
Price:*
Mirror ............................................................. $ 5.00
Musical star ....................................................$ 5.00
Teether toy .................................................... $ 5.00
Squeaker and button .................................... $ 5.00
Loop and rings .............................................. $ 5.00
Tumbler and screws ...................................... $ 5.00
Clicker and screw .......................................... $ 5.00
Duck pond and ring ....................................... $ 5.00
Cloth seat ...................................................... $ 14.50
Seat ring and bearings .................................. $ 7.00
Seat lock and screw ...................................... $ 5.00
Complete tray unit (with legs, height ............. $ 25.00
springs and height buttons)
Tray at proper height
Height buttons and height springs only ........ $ 5.00
Retainer rings ................................................ $ 5.00
Spring covers with retainer rings .................. $ 5.00
Complete base unit (with legs, retainer ........ $ 20.00
straps, spring covers, and retainer rings)
* Prices subject to change
without notice.
TRAY TOO HIGH
TRAY TOO LOW
IF YOU NEED HELP
If you have any questions, please call toll-free:
1-800-345-4109
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
Model Number SHIP TO:
(Must be filled in)
Name
Mirror
Musical star
Teether toy
Address
Squeaker and button
Loop and rings
Tumbler and screws
Clicker and screw
Duck pond and ring
Cloth seat
City, State, Zip
(
)
Telephone
Seat ring and bearings
Seat lock and screw
Complete tray unit
Height buttons and
springs
Check enclosed
(payable to Graco Children’s
Products Inc.)
Charge to credit card:
Visa
Retainer rings
Spring covers with
retainer rings
MasterCard
Discover
Complete base unit
Total:
Account #:
6% sales tax
(PA only):
Expiration date:
Signature:
Total amount
due:
291-12-97
9
10
|